Is there a way to get Cross Section Curves from Mesh?
Posted: Tue Nov 16, 2021 3:40 pm
Hi everyone,
I created a Mesh from a Point Cloud in CloudCompare. From this Mesh would I like to create Cross Sections the Same Way as you can from a Point Cloud.
In the image below I overlaid the created Mesh and the created Cross Sections (based upon the Point Cloud) as reference.
Is there a way in CloudCompare to create these Cross Sections straight from the Mesh?
Kind regards,
Daan
I created a Mesh from a Point Cloud in CloudCompare. From this Mesh would I like to create Cross Sections the Same Way as you can from a Point Cloud.
In the image below I overlaid the created Mesh and the created Cross Sections (based upon the Point Cloud) as reference.
- 2.PNG (639.39 KiB) Viewed 675 times
Kind regards,
Daan